#Intumescent paint 2 hour rating Patch#

These are approximate spread rates as there can be loss with over spray and thickness variances. The fire resistance rating of the tested specimen shall not diminish more than 25, post- weathering tests.

Fire test for fire resistance performance shall be conducted on the specimens after the weather tests. Remember this is surface area of the treatment. Coating of intumescent paint onto structural steels, and subsequent maintenance shall conform to BS 8202: Part 2. 2 - PASSIVE fire protection Fire resistant walls and floors Fire doors Fire resisting dampers Intumescent fireproofing / Intumescent fire protective coating. bag of Unifirex F-10™ dry mix= for 1 hour. Example: Thickness 3/16' inch= 30 min.,3/8' inch=1 hour, 1/2' inch = 2 hour resistance. Spread rate: Spread rate will depend on the measure of fire protection desired. (Note if applied to wood surface you may be required to treat the wood first with flame retardant for wood such as Wood Shield W-1000 or Fire Kote 100 a class A flame retardant for wood) Recommended for Commercial and Residential use. A textured finish application that can be left as is or can be painted after application.

#Intumescent paint 2 hour rating Patch#

Can also be used patch work where older coatings have chipped off. Can be applied on sheet rock, galvanized steal, iron, plywood and most other dry surfaces. Use on steel ceilings, walls, beams and columns. FireGuard E-84 intumescent coating is an intumescent paint that is especially recommended to reach 1 and 2 hour fire ratings on drywall / sheetrock for wall assemblies and floor/ceiling assemblies. Our exclusive formula with increased fire protection makes it the number one thermal coating for fire proofing. It's easier to handle, has a lighter weight and is accessible where sheet rock is difficult to set. UL Certified Intumescent Paint For Steel 325.00 FBL-200 is designed specifically for Structural Steel, with a slow carbon char expansion giving up to a 2 hour rating. The first UL-Classified Intumescent Coating with a Protected Floor Assembly rating. A better solution than fire rated gypsum board. Water-Based Intumescent coating with low VOCs. UnifireX exceeds as a superior SFRM (Spray-Applied Fire-Resistive Materials) which can out perform and out last all others. Use as a transferable fiberous coating to create a 1 or 2 hour rating for steel or other metals and materials. The Most Practical Solution to Insulating Against Heat and Flame